Main Menu - EcoWater 3500 Series Owner's Manual

ECOWATER
S Y S T E M S
CONDITIONER/REFINER STATUS SCREENS
During normal operation, the EcoWater Systems condi-
tioner/refiner's display shows up to four status screens
(Page 14 explains how individual screens can be turned
on or off). Each is shown for six seconds, in a rolling
sequence (See Figure 15).
*
Water remaining before the next recharge.
Pressing the conditioner/refiner's RIGHT ( ) button
manually advances to the next screen in the sequence.
Pressing the LEFT ( ) button manually returns to the
previous status screen. If no buttons are pressed for 30
seconds, the automatic rolling sequence resumes.
OTHER MESSAGES, ALERTS &
REMINDERS
The conditioner/refiner status screens described above
will not be displayed in a rolling sequence when one of
the following items is displayed:
Recharge status (Displayed during recharges,
showing valve position and time remaining)
Add salt or Out of salt (See Page 31)
Current time setting screen instead of status
screens indicates time has been lost, perhaps after
a long power loss. Set the time (See Page 12).
Service reminder (See Page 20)
Error detected (Contact your dealer for service)
FLASHING BACKLIGHT
The conditioner/refiner's display is backlit to make it
easy to read. The backlight will flash on and off when
one or more of the following conditions occurs:
Salt needs to be added
Time needs to be set (Time has been lost)
Service is overdue (Service reminder)
Error condition
The flashing will stop after any key is pressed.
However, it will start again at Midnight if the underlying
condition (e.g. low salt level) has not been addressed.
*
FIG. 15
9
Conditioner/Refiner Operation

MAIN MENU

During normal operation (status screens rolling), press
the conditioner/refiner's SELECT ( ) button to display
the Main menu (See Figure 16). This menu and its
subsidiary screens are used to control these operations:
Recharge (See Page 12)
Salt settings
Salt level (See Page 11)
Low salt alarm (See Page 11)
Salt type (See Page 11)
Basic settings
Current time (See Page 12)
Hardness (See Page 13)
Iron level (See Page 13)
Recharge time (See Page 13)
Rolling screens (See Page 14)
User preferences
Language (See Page 14)
Time format (See Page 15)
Volume units (See Page 15)
Hardness units (See Page 15)
Weight units (See Page 15)
System information
Model information (See Page 16)
Water available (See Page 16)
Daily avg. water used (See Page 16)
Water used today (See Page 16)
Total water used (See Page 16)
Current water flow (See Page 16)
Days powered up (See Page 16)
Last recharge (See Page 16)
Total recharges (See Page 16)
Advanced settings
Cycle times
Backwash time (See Page 17)
2nd backwash (On/Off) (See Page 17)
2nd backwash time (See Page 17)
Fast rinse time (See Page 17)
Special features
Efficiency mode (See Page 18)
Max. days between recharges (See Page 18)
Auxiliary control (See Page 19)
Chemical feed volume** (See Page 19)
Chemical feed timer** (See Page 19)
97% feature (See Page 18)
Service reminder (See Page 20)
Troubleshooting
Send E.A.S.E. message (See Page 20)
Diagnostics (See Page 21)
Setup changes (See Page 21)
Connect to remote (See Page 10)
**
Only displayed if Auxiliary control is set to Chemical feed.
FIG. 16