Setup Procedure; Panel; Conditioner/Refiner Operation - EcoWater 3500 Series Owner's Manual

ECOWATER
S Y S T E M S
Display
E.A.S.E. SELECT
Port

SETUP PROCEDURE

When the EcoWater Systems conditioner/refiner is
plugged in for the first time, a beep sounds and the dis-
play briefly shows a logo, followed by model informa-
tion. Next, a series of six "wizard" screens prompts you
to enter basic operating information:
1. LANGUAGE If the desired language already has a
black dot next to it (See Figure 8), go to Step 2.
Otherwise, press the conditioner/refiner's DOWN ( )
or UP ( ) buttons to scroll to the desired language,
then press the SELECT ( ) button to choose it.
2. Press the SELECT ( ) button to advance to the next
"wizard" screen.
3. SYSTEM UNITS If the desired system already has a
black dot next to it (See Figure 9), go to Step 4.
Otherwise, press the DOWN ( ) or UP ( ) buttons
to scroll to the desired system, then press the
SELECT ( ) button to choose it.
4. Press the SELECT ( ) button.
5. CURRENT TIME Press the DOWN ( ) or UP ( )
buttons to set the current time (See Figure 10). Hold
the button down to rapidly advance. Be sure that AM
or PM is correct. If the system units were set to met-
ric in Step 3, the clock will be in 24-hour format.
LEFT UP RIGHT
Button Button Button
DOWN
Button Button FIG. 7
FIG. 8
FIG. 9
FIG. 10

Conditioner/Refiner Operation

6. Press the SELECT ( ) button.
7. HARDNESS Press the UP ( ) or DOWN ( ) but-
tons to set the value of your water's hardness (See
Figure 11).
NOTE: Do not increase the hardness setting to
compensate for iron in your water. The
electronic control compensates automatically
after you set the iron level in Step 11, below.
8. Press the SELECT ( ) button.
9. SALT LEVEL Press the UP ( ) or DOWN ( ) but-
tons to set the salt level (See Figure 12). It should
match the lowest number visible on the brinewell
decal above the salt.
10. Press the SELECT ( ) button.
11. IRON LEVEL Press the UP ( ) or DOWN ( ) but-
tons to set the value for iron in your water (See
Figure 13). The conversion factor is 3 grains per 1
ppm of clear water iron.
12. Press the SELECT ( ) button. The screen will
show "Setup complete!" (See Figure 14).
13. If, at this point, you want to go back and make
changes, press the DOWN ( ) button to scroll to
Redo setup, then press the SELECT ( ) button
twice to repeat the six "wizard" screens.
14. If no changes are desired, make sure Run softener
has a black dot next to it (See Figure 14) and press
the SELECT ( ) button. The unit begins normal
operation, described on the next page.
8
FIG. 11
FIG. 12
FIG. 13
FIG. 14