Bridge Mode - ZyXEL Communications VMG4380-B10A User Manual

Chapter 6 Broadband
Table 8 Routing Mode (continued)
LABEL
QoS
Rate Limit
MTU
MTU Size
Apply
Cancel

6.2.1.2 Bridge Mode

Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 24 Bridge Mode (ADSL/VDSL over PTM)
The following table describes the fields in this screen.
Table 9 Bridge Mode (ADSL/VDSL over PTM)
LABEL
General
Active
Name
Type
Mode
86
DESCRIPTION
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Enter the MTU (Maximum Transfer Unit) size for this traffic.
Click Apply to save your changes back to the Device.
Click Cancel to exit this screen without saving.
DESCRIPTION
Select this to activate the WAN configuration settings.
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The Device uses
the VDSL technology for data transmission over the DSL port.
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
VMG4380-B10A / VMG4325-B10A User's Guide