Using Wps - ZyXEL Communications VMG4380-B10A User Manual

Chapter 4 Tutorials

4.3.2 Using WPS

This section shows you how to set up a wireless network using WPS. It uses the Device as the AP
and ZyXEL NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the Device. A wireless
client must also use the same PIN in order to download the wireless network settings from the
Device.
Push Button Configuration (PBC)
Make sure that your Device is turned on and your notebook is within the cover range of the wireless
1
signal.
Make sure that you have installed the wireless client driver and utility in your notebook.
2
In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button
3
(Start or WPS button).
Push and hold the WPS button located on the Device's front panel for more than 5 seconds.
4
Alternatively, you may log into Device's web configurator and go to the Network Setting >
Wireless > WPS screen. Enable the WPS function and click Apply. Then click the Connect button.
40
VMG4380-B10A / VMG4325-B10A User's Guide