Lacp Port Configuration - Planet GSW-1602SF User Manual

4.5.2 LACP Port Configuration

Link Aggregation Control Protocol (LACP) - LACP LAG negotiate Aggregated Port links with other LACP ports located on
a different device. If the other device ports are also LACP ports, the devices establish a LAG between them.
The LACP Port Configuration page contains fields for assigning LACP properties to individual ports. The screen in Figure
4-35 appears.
The page includes the following fields: table 4-11 description of the LACP Port Configuration.
Item
Port
Key Mode
LACP Enable
Key Value
Role
Button
Figure 4-35 LACP Port Configuration
Description
Indicate port 1 to port 24 (GSW-24024SF), port 1 to port 16 (GSW-1602SF).
Provide "Auto" or "Customer" for selection. Default is "Auto".
To Enable or disable the LCAP protocol on a selected port. Once the LACP protocol be
enabled, the system will start transmit the LACP control packets and exchange with another
LACP aware switch. If the linked switch didn't support LACP, then the aggregated link will not
be established.
Once set "Customer" in Key Mode, the Key Value will be filed in the LACP control packets.
Ports with same key value will be set to the same LACP Group. If two ports are set with
different key value, they will become two different LCAP groups. The key value will also be
the identify ID to the linked LACP switch.
The default setting is "0" and the available range is 1-255.
Provide "Active" or "Passive" for selection. Default is "Active".
User's Manual of GSW-1602SF / GSW-2404SF
-51-