Recording Program - Teac LCDV2657DVR User Manual

DVR Function
3. While in Time Shift mode, below operations can be use.

Recording program

After you setup the settings on the DVR File System menu, you can record a DTV program on the external
USB device.
1. Select the desired program then press the record
recording and progress bar will be displayed.
During recording, the progress bar will
Press the
and it will fade out
2. Recording stops when you press the
USB device automatically.
Press the ►PLAY button to start to play the file fresh recorded.
3.
Recording in standby mode
This unit is able to do recording while in sleep mode.
Start a recording, then
A message as shown on the right will be displayed.
Select Yes to record in standby mode.
Select no to switch unit to standby.
While recording in standby mode, unit will not output any picture or sound. The power indicator will
flash in blue and red
Press the or
speed.
Press the button to jump about 30 seconds forward.
Press the button to jump about 30 seconds backward.
Press the button to once to set the beginning point "A" and press the
button again to set the ending point "B". Then the segment A-B will be played
repeatedly. Press the
button again, an icon
in 10 seconds.
STOP button and the recorded file is stored in the external
press the power button.
consecutively while there is a
button repeatedly to increases the fast
button to cancel the repeat segment.
button on the remote control to start
fade out in 10 seconds.
will blink on the bottom right corner of the screen
recording in standby mode.
35
forward/rewind