Starting Playback; Using Headphone Set; Starting Recording; Copying Recorders - Denon PMA-1510AE Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and
the remote control
Button only on the main unit
Button only on the remote control
<SOURCE DIRECT> VOLUME
<BASS> <BALANCE>
<TREBLE> <REC OUT SELECTOR>
PHONES jack
INPUT SELECTOR
VOLUME
[MUTE]
8

Starting playback

1
INPUT SELECTOR
Use
BUTTON
The input indicator for the selected source lights.
<BUTTON>
[Selectable sources]
[BUTTON]
RECORDER-2 RECORDER-1
LINE
<POWER AMP DIRECT>
2
Play the selected source.
3
Adjust the
4
Adjust the tone with
<BALANCE>
• When the
INPUT SELECTOR
o'clock" position (over halfway), the effect of
TREBLE
• When the
all the way clockwise, the bases and treble can no longer be
adjusted.
[AMPLIFIER POWER]
5
If there is no need to adjust the tone, press
DIRECT>
• When switched "hON", the signal does not pass through
the tone adjustment circuitry (bass, treble and balance),
resulting in playback of a higher sound quality.
• When set to "jOFF", the sound can be adjusted to suit
your taste.
6
Press
• The power indicator on the main unit blinks red.
• Press again for sound.

Using headphone set

Plug headphones into PHONES jack.
• The speaker output turns off when the headphones are plugged in.
• To prevent hearing loss, do not raise the volume level excessively
when using headphones.
to select the source.
PHONO CD
VOLUME
to the desired level.
<BASS> <TREBLE>
, and
.
VOLUME
control knob is turned just past the "12
BASS
adjustments decreases.
VOLUME
control knob is turned to maximum or
<SOURCE
.
[MUTE]
to mute the sound.

Starting recording

1
<REC OUT SELECTOR>
Set
you wish to record.
TUNER
2
Set the recorder to the record mode.
3
Start playing the source to be recorded.
NOTE
The recording source switches
recording.

Copying recorders

and
1
<REC OUT SELECTOR>
Turn the
"RECORDER-1 1 2" (or "RECORDER-2 1 1").
[Selectable sources]
RECORDER-1 2 RECORDER-2
1
b When copying from a device connected to the
"RECORDER-1" terminal to a device connected to the
"RECORDER-2" terminal, select "RECORDER-1 1 2".
b When copying from a device connected to the
"RECORDER-2" terminal to a device connected to the
"RECORDER-1" terminal, select "RECORDER-2 1 1".
2
Set the device connected to the RECORDER-1 (or
RECORDER-2) terminal to the record mode.
3
Start playback on the device connected to the
RECORDER-2 (or RECORDER-1) terminal.
• The sound to be recorded can be heard by selecting the playback
INPUT SELECTOR
source with the
be heard by selecting the recorder.
• When performing these operations, also refer to the operating
instructions of the other devices.
NOTE
The sound may be interrupted or noise may be recorded if
SELECTOR
is operated during recording.
to the program source
INPUT SELECTOR
is operated during
and select
1
1
, while the recorded sound can
INPUT