What To Do If - Electrolux EOB42100 User Manual

45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure
in reverse.
The oven door has 2, 3 or 4 panels of
glass (depends on the model)
Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge
of the door at the two sides and push in-
wards to release the clip seal.

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven lamp does not operate The oven lamp is defective
F11 appears in the clock display The meat probe has short cir-
2. Pull the door trim to the front to remove
3. Hold the door glass panels on their top
4. Clean the door glass panels.
Possible cause
The oven is not switched on
The clock is not set
The necessary settings are not
set
The fuse in the fuse box is re-
leased
cuit or the plug of the meat
probe is not tightly in position in
the socket
2
B
it.
edge one by one and pull them up-
wards out of the guide
To install panels follow the procedure in
reverse. Insert the smaller panel first,
then the larger.
Switch on the oven
Set the clock
Control the settings
Control the fuse. If the fuse is re-
leased more than one time, re-
fer to a qualified electrician.
Replace the oven lamp
Insert the plug of the meat
probe as far as it will go into
the socket on the side wall of
the oven
electrolux 17
1
Remedy