Any electrical work required to install this hob should be
carried out by a qualified electrician or competent person, in
accordance with the current regulations.
THIS HOB MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not
This hob is designed to be connected to a 230 V 50 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same
as that indicated on the hob rating plate. The rating plate is located on the
bottom of the hob. A copy is attached on the back cover of this book.
The hob is supplied with a 3 core flexible supply cord incorporating a 3
amp plug fitted. In the event of having to change the fuse, a 3 amp ASTA
approved (BS 1362) fuse must be used.
Should the plug need to be replaced for any reason, the wires in the mains
lead are coloured in accordance with the following code:
Green and Yellow
1. Connect the green and yellow
(earth) wire to the terminal in the
plug which is marked with the
letter 'E' or the earth symbol
or coloured green and yellow.
2. Connect the blue (neutral) wire to
the terminal in the plug which is
marked with the letter 'N' or
3. Connect the brown (live) wire to the terminal in the plug which
is marked with the letter 'L' or coloured red.
Upon completion there must be no cut, or stray strands of wire present
and the cord clamp must be secure over the outer sheath.
A cut off plug inserted into a 13 amp socket is a serious safety
(shock) hazard. Ensure that the cut off plug is disposed of