Download Print this page

Installation; Gas Connection - Electrolux EHG 75932 Instruction Booklet

Electrolux gas hob
Hide thumbs


Table of Contents
For appliances installed in the Republic of Ireland please refer to NSAI- Domestic
Gas Installation I.S 813 Current Edition Section 7- Permitted Locations of Appliance.


Any gas installation must be carried out by a GAS SAFE
REGISTER installer.
Please, ensure that, once the hob is installed, it is easily accessible for the engineer
in the event of a breakdown.
The manufacturer will not accept liability, should the above instructions or any of the
other safety instructions incorporated in this instruction booklet be ignored.
On the end of the shaft, which includes the G 1/2" threaded elbow, adjustment is
fixed so that the washer is fitted between the components as shown in the diagram.
Screw the parts together without using excessive force.

Gas Connection

Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e.
steel or copper.
The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).
When the final connection has been made, it is essential that a thorough leak test
is carried out on the hob and installation.
Ensure that the main connection pipe does not exert any strain on the hob.
It is important to
correctly, with the
shoulder on the end of
the thread, fitted to
the hob connecting
Failure to ensure the
correct assembly will
cause leakage of gas.
A) End of shaft with nut
B) Washer
C) Elbow
electrolux 17


Table of Contents

  Related Manuals for Electrolux EHG 75932

This manual is also suitable for:

Ehg 90932