English Important Safety Information These warnings are provided in the interest of safety. You read them carefully before MUST installing or using the appliance. About Installation, Cleaning and Maintenance • Under no circumstances should you attempt to repair • It is mandatory that all operations required for the the appliance yourself.
Electrical Connection Adaptation to different types of gas Building In This appliance complies with the following MANUFACTURER: ELECTROLUX HOME PRODUCTS ITALY S.p.A. E.E.C. Directives: Viale Bologna, 298 73/23 - 90/683 (Low Voltage Directive); 47100 FORLÌ (Italy) 89/336 (Electromagnetical Compatibility Directive);...
Using the hob correctly To ensure maximum burner efficiency, it is strongly Burner minimum maximum recommended that you use only pots and pans with a diameter diameter bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (Fig. 2 -a). Large (rapid) 180 mm.
Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or maintenance work. General cleaning Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food.
Gas connection Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed.
Electrical Connection The following instructions about installation RIGID COPPER PIPE OR must be carried out by qualified personnel in TUBO RIGIDO IN RAME FLEXIBLE PIPE IN STAINLESS O FLESSIBILE IN compliance with the regulation in force. STEEL ACCIAIO INOX The appliance is designed to be connected to 230 V monophase electricity supply.
Adaptation to different types of gas Injectors replacement ! ! ! ! ! • Remove the pan supports. • Remove the burner's caps and crowns. • With a socket spanner 7 unscrew and remove the injectors (Fig. 7), and replace them with the ones required for the type of gas in use (see table 2).
Building In Mod. EHM 6731 Mod. EHM 6722 Mod. EHG 671 These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in the relevant diagram. The edge of the cut out must have a minimum distance from the rear wall of 55 mm.
Fitting the hob to the worktop Dimensions are given in millimeters The hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. 9. To install the hob, proceed as follows: 1) Remove the pan supports, the burners caps and crowns and turn the hob upside down, taking care the ignition candles are not damaged in this operation.
Possibilities for insertion Kitchen unit with door Kitchen unit with oven Proper arrangements must be taken in designing the The hob recess dimensions must comply the indication furniture unit, in order to avoid any contact with the given in Figs. 13 and 14 and must be provided with bottom of the hob which can be heated when it is brackets to allow a continuous supply of air.