Table of Contents
Advertisement
5 – Program and cue playback
Program playback
You can create a program in advance to play up to 99 tracks you
want in the desired order.
Program menu operation
Select
and press the DATA dial to open the
PROGRAM EDIT
screen (program list). Select the desired item, and
PROGRAM
press the DATA dial to open the
following options.
ADD PROGRAM
Adds the highlighted track to the program.
DELETE ALL PROGRAM
Removes all tracks from the program.
DELETE PROGRAM
Removes the selected program track.
MOVE
Move the selected program track to a different position in the
program order.
CANCEL
Close the
without conducting any operation and
PROGRAM MENU
return to the
screen.
PROGRAM
Adding tracks to a program
Follow these procedures to set up a program.
1.
With playback stopped, press the PLAY MODE button
and set the playback mode to
playback mode" on page 17.)
Press the MENU button to open the
2.
3.
Open the
menu.
PROGRAM/CUE
4.
Select
.
PROGRAM EDIT
5.
Press the DATA dial to open the
6.
Turn the DATA dial to select the number in the program
where a track will be added, and press the DATA dial to
open the
menu.
PROGRAM
7.
Turn the DATA dial to select
24
TASCAM CD-9010
pop-up with the
PROGRAM MENU
(See "Setting the
PROGRAM
screen.
MENU
screen.
PROGRAM
.
ADD PROGRAM
8.
Press the DATA dial to open the
screen.
PROGRAM)
Turn the DATA dial to program to select a track, and press
9.
the DATA dial to add the track to the program.
10. Repeat steps 6–9 to add more tracks to the program as
desired.
The screen shows the number of tracks in the program
and the total program time.
NOTES
•
You can add the same track to the program more than once.
•
You can add a maximum of 99 tracks to a program. If you
try to program a 100th track, a PROGRAM FULL warning
message pop-up appears.
•
If the total time of the programmed tracks exceeds 99 hours
59 minutes, 59 seconds, "
- -: - -: - -
display.
•
A program can only include tracks from one CD. After tracks
have been added to a program from one CD, if you try to
add a track using a different CD, a "–Cannot Program–"
message will appear and the track will not be added.
11. When you have finished entering tracks to the program,
press the HOME button to return to the Home Screen.
12. Press the MONITOR button or PLAY button to start
program playback.
NOTES
•
If you set PROGRAM playback mode but no tracks have
been added to the program, the setting will change to
CONTINUE when playback starts.
•
Program settings are retained even when the power is
turned OFF.
•
If you try to start program playback when a CD that is
different from the one used by the program, a "–Can't Play
Program–" message will appear and playback will not start.
BROWSE (ADD
" appears on the
Advertisement
Table of Contents
