Master Clock And Digital Output Combinations; Setting The Master Word Clock; Mono Mix Setting - Tascam CD-9010 Owner's Manual

7 – Other settings and information display

Setting the master word clock

You can set the source to use for word synchronization.
1. Press the MENU button to open the
2. Open the menu.
SYSTEM
3. Select .
CLOCK MASTER
4. Press the DATA dial to move the cursor right to select the
setting.
Turn the DATA dial to set the master word clock.
5.
•
(default value): Use the unit's internal clock
INT
•
: Synchronize with the word clock input through the
EXT
WORD SYNC IN connector
•
: Regardless of the file sampling frequency,
44.1K FIX
digital audio is always output at 44.1k FS.
6. After completing the setting, press the HOME button to
return to the Home Screen.
NOTE
•
The master clock setting is retained even when the power is
turned OFF.
•
Depending on the combination of master clock and
playback file sampling frequency settings, the digital output
sampling frequency will differ. (See "Master clock and digital
output combinations" below.)

Master clock and digital output combinations

Depending on the combination of the master clock setting and the playback file sampling frequency, the digital output sampling
frequency varies. This table shows the combinations.
Master Master clock Playback file
clock setting sampling frequency
44.1 kHz
INT
44.1 kHz
44.1kHz FIX
Internal
48 kHz
44.1kHz FIX
48 kHz
INT
External
44.1 kHz
EXT
(44.1kHz)
44.1 kHz
EXT
External
(48kHz)
48 kHz
EXT
NOTE
•
The sampling rate converter (SRC) function is turned ON and OFF automatically.
•
If the clock is interrupted when synchronized with a 48kHz external clock, the unit will switch to internal clock, the sampling rate
converter (SRC) function will turn ON and output will continue at 48 kHz.
30
TASCAM CD-9010
screen.
MENU
SRC Digital output
(automatic) sampling frequency
OFF 44.1 kHz
OFF 44.1 kHz
ON 44.1 kHz
OFF 48 kHz
OFF 44.1 kHz
ON 48 kHz
OFF 48 kHz

Mono mix setting

You can set the mono mix output for when the STEREO/MONO
button is used to set the output to mono. The setting state is
shown to the left of the level meters.
1. Press the MENU button to open the
2. Open the SYSTEM menu.
3. Select .
MONO MIX
4. Press the DATA dial to move the cursor right to select the
setting.
Turn the DATA dial to set the mono mix.
5.
The left and right channels of the stereo
audio track are each attenuated by –6 dB,
–6dB L+R
summed and then output.
The left and right channels of the stereo
audio track are each attenuated by –3 dB,
–3dB L+R
summed and then output.
The left channel of the stereo audio track is
L Mono
output from both L and R outputs.
The right channel of the stereo audio track
R Mono
is output from both L and R outputs.
OFF
The mono mix function is OFF.
(default
value)
6. After completing the setting, press the HOME button to
return to the Home Screen.
NOTE
The mono mix setting is retained even when the power is turned
OFF.
Notes
The whole system uses 44.1kHz internal clock
Digital output is always 44.1 kHz
Digital output is always 44.1 kHz
The whole system uses 48kHz internal clock
The whole system uses 44.1kHz external clock
While syncing to 48kHz external clock, the
system uses 44.1kHz internal clock
The whole system uses 48kHz external clock
screen.
MENU