Operational Features - EFD 2000XL Operating Manual

Note: The pedal needs only to be pressed mo-
mentarily. The complete time cycle will run once
the dispenser is initiated.
Press RUN/SETUP and toggle back to the SETUP
mode. Press the TIME SET buttons and change
the time to 2.30 seconds. Go back to RUN, press
the foot pedal, and the dispenser will make a
deposit approximately twice the size of the first one.
Pressure—changes deposit size.
The dispenser should be in the RUN mode, the
TIME setting should be 2.30 seconds and the
dispensing pressure should be 20 psi (1.4 bar).
Increasing the pressure will result in larger depos-
its, decreasing the pressure will result in smaller
deposits. Try this now and observe the results.
Tip Size—changes deposit size.
Tip size also affects deposit size. Without chang-
ing the TIME or PRESSURE setting, try different tips
and observe the results.
If you have any questions at this point, please call us now.
In the US, call 800-556-3484
(Between 8:30 am and 6:00 pm eastern time.)
In Mexico, call 001-800-556-3484.
In the UK, ring free 0800 585733.
Don't Forget!
Changes to the time settings can be
made only when the mode of operation
is SETUP.
RUN mode locks out TIME SET and TEACH
control buttons. Use this to protect the
setup from inadvertent changes.
Pressing STEADY/TEACH in SETUP mode
will clear all time settings within cell.
STOP immediately terminates the current
dispense cycle.
Use only dry, clean, filtered air.