Table of Contents
Advertisement
Setting the delay start
With the delay start you can delay the start of a dishwashing cycle for
between 1 and 19 hours. First of all set the delay start and then the desired dish
washing cycle.
1. Go to the DELAY START option; see section "Adapting an option/setting".
2. Set the period by which you wish to delay the start in hours.
In the symbol line of the display
3. Press the OPTION button, to change to the Programmes menu.
4. Select programme and start.
First of all the pre set time delay until the start runs down. In the display you see
the time remaining until the start of the dishwashing cycle. After the time delay
until the start has elapsed, the dishwashing cycle starts automatically, the
symbol
Cancelling a delay start:
You can cancel a delay start that is counting down at any time.
1. Press the RESET button.
In the display: CONFIRM CANCEL ?
2. Press the OK/START button.
The delay start is cancelled. The dishwasher cycle that is set begins.
Switching off the dishwasher
Switch off the dishwasher if the messages PROGRAMME END and PLEASE
SWITCH OFF are being displayed alternately.
With some dishwashing cycles, the drying fan continues to run even after the
end of the cycle.
If the acoustic signal has been enabled, a continuous tone will sound for approx.
15 seconds at the end of the dishwashing cycle.
If the dishwasher is not switched off, then the acoustic signal is repeated after 3
minutes and after 6 minutes.
1. Press the ON/OFF button. Display goes out.
2. Turn off the water tap.
Carefully open the door. Hot steam may escape.
• Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about
15 minutes before removing them. You also get a better drying result.
• Dishes dry more quickly if you open the door for a moment after the cycle has
ended and then leave it slightly open.
goes out.
.
31
In daily use
Advertisement
Table of Contents
