Care - C-SCOPE CS4PI Operating Instructions Manual

We recommend a pulse frequency setting within the green zone on the control scale. It may
be necessary to change to a different pulse frequency to avoid interference from extraneous signal
sources. Experimentation with different metal targets will show you how the pulse frequency can
affect sensitivity to different metals.
When the detector gives a signal, move the search-head to the approximate area where the
signal was heard, and reduce the arc of your sweep so that the search-head is just passing back and
forth a few centimetres either side of the signal. In this way you can identify the exact target position.
(The most sensitive part of the search-head is below its centre). Dig a neat hole by cutting around the
signal position with a sharp edged trowel and remove a divot of earth which might now contain the
metal object. Run the detector over the area again to see if the metal object is still in the hole or in
the piece of earth which you have just removed.
Dig some more and sift through the earth until you find what you are looking for. Fill in the hole
before moving on. (recovering finds in sand is very much easier with a sand scoop - a trowel like a
sieve where the sand is able to run out leaving the find in the scoop).
The use of headphones will increase battery life and make it easier to discern faint signals.
Follow the 'Country Code'. Do not trespass. Do not touch anything you suspect might
be live ammunition - inform the police. Do not take your detector on any scheduled historic
site. If you find anything which looks like it could have historical significance, report it to
your local museum.
Acquaint yourself with any laws relating to the use of metal detectors if you want to go
detecting in countries other than the UK.
deor care
The CS4PI is a robust design, however the control box should be treated with similar care as
any electronic product. Dry off any water splashes immediately. The search-head may be immersed
in water. Stem and search-head parts should be cleaned and dried at the end of a day's detecting.
Do not use solvents. If the detector has been used on a beach it will be necessary to wash sand
and salt residue off the stem adjustment mechanism and the search-head retaining parts using tap
water. Remove batteries if the detector is going to be stored for any length of time. Do not open the
controlbox front panel. There are no user serviceable parts inside and you may invalidate your warranty.
warranty & service
Your CS3MX is guaranteed free of manufacturing defects as confirmed in our written warranty
document. Contact us if you have any concerns about the operation of your detector.
The C.SCOPE Customer Service Team really know about metal detectors and are always ready with
good advice and rapid after-sales-service.
C.SCOPE is an ISO 9001 Quality Manufacturer.
This equipment conforms to the EMC directive
89/336/EEC.
System performance may be impaired by
unusually strong electromagnetic fields.
4
CS PI
7