Table of Contents
Advertisement
OPERATING YOUR CS7
Check the batteries are in good condition prior to, and frequently during the search. With the search
head away from metals, the THRESHOLD control is increased to the point just below that at which the
continuous audio tone is heard. This is the setting that will allow the user to get the best results.
The FREQUENCY control can then be adjusted to the desired position. At first set the control to the
mid position and when you are ready to progress adjust the control to learn the effect on different
targets. It is instructive to bury some metallic objects in a clear area and note the response when swept
at different rates with FREQUENCY at various levels.
IMPORTANT CONSIDERATIONS
The Pulse Induction technique of metal detection is highly iron-sensitive. Unlike conventional induction
balance metal detectors, it is not possible to isolate ferrous objects as a specific category of material.
Care must be exercised in the use of the frequency change control. Settings that are too low will
eliminate metal foil but some other thin section objects such as rings and coins may also be rejected on
these settings. It is vital to test your machine on the type of objects you wish to find and ensure that your
machine settings are right for the job in hand.
The CS7 is a MOTION PULSE design which means that the search-head must be kept in
motion with a steady swing from side to side in order for it to work to maximum effect. It is
possible to sweep the head too fast over a faint target - get the feel of this by practice, and sweep the
detector head accordingly.
ACCESSORIES (OPTIONAL) AVAILABLE FROM C-SCOPE
Rechargeable battery pack: A shrink wrapped pack of 8 high capacity rechargeable nicad
batteries to replace the standard batteries and holder.
Battery charger: The C-Scope battery charger is designed to charge the rechargeable pack quickly
and safely.
Belt mount: Rugged belt complete with stainless steel mounting plate for the control box.
For further information, and a price list, for all C-Scope accessories please telephone
44(0)1233
629181.
CARE OF YOUR DETECTOR
When not in use your detector should be stored in a dry warm environment. If it is not to be used for a
certain length of time it is advisable to remove the batteries to avoid leakage which could cause serious
damage. The working life of your detector will be shortened by careless use or neglect of the unit. Think
of your detector as a scientific instrument. Your detector is designed to withstand rugged handling on
11
Hide quick links:
Advertisement
Table of Contents
