Connection Status - Pppoe - Hawking HWR54G User Manual

Connection Status - PPPoE

If using PPPoE (PPP over Ethernet), a screen like the following example will be displayed
when the "Connection Details" button is clicked.
Data - PPPoE Screen
Connection
Physical Address
IP Address
Network Mask
PPPoE Link Status
Connection Log
Connection Log
Buttons
Connect
Figure 23: PPPoE Status Screen
The hardware address of this device, as seen by remote devices
on the Internet. (This is different to the hardware address seen by
devices on the local LAN.)
The IP Address of this device, as seen by Internet users. This
address is allocated by your ISP (Internet Service Provider).
The Network Mask associated with the IP Address above.
This indicates whether or not the connection is currently
established.
•
If the connection does not exist, the "Connect" button can be
used to establish a connection.
•
If the connection currently exists, the "Disconnect" button
can be used to break the connection.
•
The Connection Log shows status messages relating to the
existing connection.
•
The most common messages are listed in the table below.
•
The "Clear Log" button will restart the Log, while the
Refresh button will update the messages shown on screen.
If not connected, establish a connection to your ISP.
Operation and Status
37