Page 5
URL section and hit ENTER. Users: - Do NOT insert the Setup CD-Rom. - Open your Web-Browser (Safari or Internet Explorer) - Type in http://192.168.1.254 in your URL section and hit ENTER. HWR54G Rev R Hawking Technologies, Inc.
When the menu bar on the left loads, select the “SETUP WIZARD” option on the top menu bar. Select NEXT to continue with the installation. HWR54G Rev R Hawking Technologies, Inc.
Hawking strongly recommends that this information is NOT changed. If you forget your LAN IP Address you may reset it to the original IP by resetting the router. (See manual)
Page 8
PPTP – A DSL service ONLY used in EUROPE. Check with your ISP for setup information. L2TP – A rare connection type for DSL. Check with your ISP for setup Information. Select NEXT to continue HWR54G Rev R Hawking Technologies, Inc.
This page will guide you through your initial setup for wireless access. If you do not wish to use wireless access in your network you may select Disable Access Point. Band: Hawking recommends using B+G for your band settings. The band settings let you set your wireless access for 802.11b, 802.11g or both networks.
WIRELESS SECURITY SETUP Hawking recommends that you enable wireless security within your network. Note that implementing wireless security may have an impact on your network’s performance, but if you are transmitting sensitive data, enabling wireless security should give you peace of mind that your network is safe from intruders.
Please save your encryption keys in a safe place. (If you happen to forget your key you may reset the router to regain access) Your router is now successfully setup for wired and wireless networking! HWR54G Rev R Hawking Technologies, Inc. P 10...
Page 12
Note: If your computer is not loading the Setup Wizard page during initial setup you may also follow the following steps to correctly configure your PC. HWR54G Rev R Hawking Technologies, Inc. P 11...
Page 13
3.) Be sure to check the selection entitled “Obtain an IP address automatically” if it has not yet been chosen. Select OK. Your computer may request for you to reboot at this time. If so, reboot and test your connection. HWR54G Rev R Hawking Technologies, Inc. P 12...
Page 14
5.) Drop down the Configure IPv4 window and select Using DHCP 6.) Click on Renew DHCP Lease and the select Apple Now. Your Mac IP settings are now setup for dynamic networking. Please test your internet connection again. HWR54G Rev R Hawking Technologies, Inc. P 13...
Page 15
HWR54G Rev R Hawking Technologies, Inc. P 14...