Gold's Gym XR25 GGBE24320 User Manual page 8

10. Pull the Adjustment Knob (19) out as far as it will
go. Insert the Adjustment Bracket (8) into the slot
in the Bench Frame (2) and engage the Knob into
one of the holes in the Bracket.
Attach the Backrest Frames (7) to the Bench
Frame (2) with an M10 x 180mm Bolt (37), two
M10 Washers (38), and an M10 Nylon Locknut
(32).
Tighten the four M10 Nylon Locknuts (32) and
the four M6 x 53mm Screws (42) used in steps
8 and 9.
11. Attach the Seat (10) to the Bench Frame (2) with
four M6 x 16mm Screws (35).
12. Slide a Pad Tube (26) through the hole in the
Front Leg (3). Slide two Foam Pads (15) onto the
ends of the Pad Tube. Press two 19mm Round
Inner Caps (25) into the ends of the Pad Tube.
Repeat this step with the other two Pad Tubes
(26) and the Leg Lever (41).
13. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in
ADJUSTMENTS starting on the next page.
10
37
38
7
19
11
10
Wide
End
12
25
3
15
41
26
26
8
38
2
32
8
2
35
35
15
26
25