Instruction On Setting Up; Setting Up; Making The Appliance Level - AEG COMPETENCE 41016VI Installation And Operating Instructions Manual

Instruction on setting up

1
Important! The new appliance may only be installed and connected by
qualified personnel.
Please observe this instruction, otherwise the warranty will not cover
any damage that may occur.

Setting up

• In the units or furniture surrounding the appliance, veneers or plastic
coatings must have been made up using heat-resistant bonding
agents (100°C). If plastic coatings or cements are not sufficiently
heat-resistant, the coating may be deformed or loosened.
• With regard to fire hazard protection, the appliance corresponds to
type Y (EN 60335-2-6). Only appliances of this type may be installed
up against tall units or a wall (on one side).
• The distance between the cooking surface and the cooker hood must
as a minimum be as great as that indicated in the installation instruc-
tions for the cooker hood.

Making the appliance level

Underneath the appliance there are
4 adjustable feet, which can be used
to even out small unlevelnesses in
the floor.
1. Remove the pan drawer.
2. Turn the adjustable feet to make
them higher or lower as required,
until the cooker is standing level.
3. Re-insert the pan drawer.
3
The adjustable feet are easier to
turn, if the cooker is tilted slightly
to take the weight off the foot.
52