Table of Contents
Advertisement
If you press
of the END
When END function is activated the Timer/Residual heat indicator shows relation between
Time of day and END time set.
Setting the MINUTE MINDER
Use to set a countdown (maximum 23:59 minutes) This function has no effect on the
operation of the oven
Set the function when the appliance is off:
1. Press
and " 00 " flash in the display.
2. Press
3. Use the same procedure to set minutes and hours.
When you set hours, minutes replaced seconds on the display and hours replaced mi-
nutes. Symbol
4. MINUTE MINDER starts to operate automatically after 5 seconds.
After 90% of set cooking time an acoustic signal sounds.
5. When set time ends, an acoustic signal sounds for 2 minutes and " 00:00 " and
in the display.
You can set the MINUTE MINDER any time, even if the oven is off.
If you set the MINUTE MINDER when DURATION or END is running, the symbol
the display. The Timer/Residual heat symbol shows relation between set and current DU-
RATION (or END) time.
Counter
Use the Counter to monitor how long the oven operates. It is on immediately when the
oven starts to heat.
Reset the Counter: press
and
then the Counter start to count up again.
You can not use Counter when Duration or End is set.
USING THE ACCESORIES
WARNING!
Refer to "Safety information" chapter.
Core temperature sensor
Core temperature sensor measures the core temperature of the meat. When the meat is at
the set temperature, the appliance deactivates.
button during setting hours for DURATION
function.
.
or
to set the seconds.
comes on the display.
again and again to see the Counter function. Press and hold
Using the Accesories
, the appliance goes to setting
11
flash
goes on
Advertisement
Table of Contents
