Table of Contents
Advertisement
125981560.qxp
2005-09-08
12:50
Adjusting the Level of Conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the
appliance.
In selection mode press the "Options" button until the
Set Up menu appears on the display.
Press "Change" button to enter in the Set Up menu
and then press the "Options" button sequentially
until the message "Water hardness" appears.
Adjusting the level of conductivity:
Pressing "Change" button you can choose the
required water hardness degree.
The level of water hardness is indicated by 3 degree
shown on the display: hard, normal and soft.
Page 6
6
Conductivity
Display
degree
S O F T
Low
N O R M A L
Medium
H A R D
High
Memorising the new setting:
To fix your choice press the "Exit" button.
The previous selected drying cycle and options
appears again on the display and the buzzer sounds.
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Approximative
value ºdH
< 14
15 - 21
> 21
Advertisement
Table of Contents
