Table of Contents
Advertisement
125981560.qxp
2005-09-08
12:50
6. Turn the selector dial, in order to select the
desired programme. The relevant message will
appear in the display.
The display will show the end cycle time «Cycle
end at» of the selected programme, calculated
on the basis of the maximum load for each type
of fabric. The Start/Pause button light will start
flashing.
If the load of laundry to be dried is small, at the
beginning of the cycle the display will still
indicate the end cycle relevant to the maximum
load.
The duration value will be gradually adjusted
during the execution of the drying cycle.
7. Press the WET button repeatedly, in order to
select the desired degree of dampness. See
below the possible combinations.
Extra dry for coton, coton quick, synthetic
●
programmes
●
Strong dry for cotton, cotton quick programmes
Cupboard dry for cotton, cotton quick, synthetic
●
programmes
●
Damp dry for cotton programmes
Iron dry for cotton, synthetic programmes
●
Machine dry for cotton programmes
●
8. Press the SPIN button repeatedly, in order to
select the real spin speed that your laundry has
been spun. The selected spin level will be shown on
the third row above to the spin button.
9. Press the «Options» button to select the required
options.
To confirm your choice press the "Change"
("Wijzigen") button.
Depending on the selected programme only
Page 18
18
certain options are available and shown
during the selection phase.
Note: Not all the options are compatible
between themselves. The incompatible option
icons will disappear.
10.Select the DELAY START option if required.
Before you start the programme choose the
required option.
The selected delay time value (up to 20 hours)
will appear on the display while selecting.
The end cycle will be updated and shown on the
relative position of the display.
11.Press the Start/Pause button. The relevant light
will stop flashing. The message relevant to the
phase that is in progress will be shown in the
display.
If you have chosen a delayed start, the tumble
dryer will begin the countdown.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound and the «Selection error»
message appears in the display.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (on the second row of the display
appears the «Cooling» message).
You may remove the laundry after this phase.
The display shows the following messages one
after an other: «Please clean the filters» and
«Please empty the tank». The buzzer sounds to
indicate the end of the cycle.
12.If the laundry is not removed at the end of the
Advertisement
Table of Contents
