Adjusting The Level Of Conductivity - Electrolux EDC 5349 Instruction Booklet

Table of Contents

Advertisement

125980820 gb.qxp
2005-01-04

Adjusting the Level of Conductivity

Water contains, a variable quantity of limestone
and mineral salts of which quantities vary
according to geographical locations thus
varying its conductivity values.
Relevant variations of the conductivity of the
water compared to those prefixed by the
factory could slightly influence the residual
humidity of the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity
of the drying sensor based on conductivity
values of the water by using the following
procedure.
Procedure:
Turn the programme selector dial to switch on
the appliance.
In selection mode press the "Opties" button
until the Set Up menu appears on the display.
Press "Wijzigen" button to enter in the Set Up
menu and then press the "Opties" button
sequentially until the message "Water
hardness" appears.
Adjusting the level of
conductivity:
Pressing "Wijzigen" button you can choose the
required water hardness degree.
The level of water hardness is indicated by 3
degree shown on the display: hard, normal and
soft.
12:58
Page 5
Conductivity
Display
degree
S O F T
Low
N O R M A L
Medium
H A R D
High
Memorising the new setting:
To fix your choice press the "Terug"button.
The previous selected drying cycle and options
appears again on the display and the buzzer
sounds.
Normally, the appliance is factory-set to the
highest level; however, certain models may
be configured differently.
5
Approximative
value ºdH
< 14
15 - 21
> 21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents