Table of Contents
Advertisement
125981560.qxp
2005-09-08
12:50
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase. The display will show the following
messages one after an other: «Anticrease»,
«Please clean the filters» and «Please empty
the tank». The buzzer sounds to indicate the end
of the cycle.
The light of the Start/Pauzs button goes off and a
flashing zero appears on the display.
13.Turn the programme selector dial to "0"; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the programme selector dial to "0",
the machine is ready to perform another
drying programme. The display shows the
selected programme, duration of the
programme and the options required.
Page 19
19
After each use
• Clean the filters (see page 19).
• Empty the water reservoir (see page 20).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position «Cooling» and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance. To do this first turn the dial to "0" and then
to «Cooling» and press Start/Pause button .
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"0". Select the new programme and press the
Start/Pause button.
Advertisement
Table of Contents
