Table of Contents
Advertisement
Problem
Loading door does not close.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
Changing the bulb for interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force cen-
tre.
Warning! When the appliance is
switched on, the interior lighting
switches itself off after 4 minutes when
the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug.
Machine settings
BUZZER SIGNAL permanent off
1. Turn the programme selector to any pro-
gramme.
2. Press simultaneously theDELICATE and
LONG ANTICREASE buttons and hold
down for approx. 5 seconds.
3. The buzzer is by default always off. You
can use BUZZER button to activate or
deactivate sound but machine does not
memorize your selection.
Water hardness
Water contains, a variable quantity of lime-
stone and mineral salts of which quantities
vary according to geographical locations
thus varying its conductivity values. Relevant
variations of the conductivity of the water
compared to those prefixed by the factory
could slightly influence the residual humidity
Possible cause
Conductance of water at instal-
lation site differs from standard
setting of machine.
Filter not in place.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
1. Unscrew cover above the bulb (this can
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light cov-
er. Do not operate the dryer when missing o-
ring gasket on door light cover.
of the laundry at the end of the cycle. Your
dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity val-
ues of the water.
1. Turn the programme selector to any pro-
2. Press simultaneously the LONG ANTI-
3. Press the START/PAUSE button sequen-
4. To memorize setting press simultaneous-
Re-programme standard setting
for degree of drying (see 'Pro-
gramming options' chapter).
Install filter into place.
Select time programme or high-
er drying level (e.g. EXTRA in-
stead of CUPBOARD ).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
be found directly behind the loading aper-
ture, at the top; refer to "Description of
machine" section.)
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
gramme.
CREASE and START/PAUSE buttons
and hold down for approx. 5 seconds.
The current setting is on the lights: END/
ANTICREASE– low conductivity <300
micro S/cm, COOLING – medium con-
ductivity 300-600 micro S/cm, COOLING
and END/ANTICREASE– high conductiv-
ity >600 micro S/cm
tially until you set desired level.
ly the LONG ANTICREASE and START/
electrolux 11
Remedy
Hide quick links:
Advertisement
Table of Contents
