Error Code - Electrolux EOC 6500 Instruction Booklet

Demo mode
This mode is intended to be used in the shops to dem-
onstrate the oven functionality without any power con-
sumption except the oven lamp. To activate this func-
tion the appliance should be in stand-by mode.
—
Press button and
onds (Fig. 17). An acoustic alarm will sound for a
short time.
—
Press button and the "
in the display.
All oven functions can be selected.
The thermometer symbol will not flash anymore and
id
" " indication will be replaced by number digits.
Follow the above described procedure to disable
the demo mode.
Beep mode
You can choose to make The Electronic Control beep
each time that a control is touched.
To enable this function, the oven must be off.
1. Press controls and
3 seconds. The Electronic Control beeps once.
To disable the "Beep" Function:
1. If the oven is on, press control
2. Press controls and
3 seconds. The Electronic Control beeps once.

Error code

The electronic programmer does a continuous diag-
nostic check of the system. If some parameters are
not correct, the control unit will stop the activated func-
tions and the corresponding error code (letter "F" fol-
lowed by number digits) will be displayed.
For further details, refer to chapter "Something not
working" on page 21.
" "
for approximately 2 sec-
id
" indication will appear
" "
at the same time for about
to switch it off.
" "
at the same time for about
Fig. 17
11