Table of Contents
Advertisement
If you wish to directly connect to the mains,
you have to interpose an omnipolar switch
with a minimum opening between contacts
of 3 mm, between the unit and the mains,
complying with the existing regulations.
The brown live wire (originating from the
clamp of the appliance junction box) must al-
ways be connected to the phase of the mains
supply. In any case, the supply cord must be
positioned in such a way as it does not reach
in any point a temperature higher by 50
than the room temperature.
Replacement of the electric cable
Warning! The replacement of electric
cable must be carried out exclusively by
the service force centre or by personnel
with similar competencies, in
accordance with the current regulations.
Should the supply cord need to be replaced,
use only the following cable types: H07 RN-
F, H05 RN-F, H05 RRF, H05 VV-F, H05
V2V2-F (T90), H05 BB-F. It is necessary that
the yellow/ green earth wire is about 2 cm
longer than the live and neutral ones (see di-
agram).
The section of the cable should be 3 x 1,5
2
mm
minimum.
After the connection, test the heating ele-
ments for about 3 minutes to ensure that they
are working correctly.
Important! The manufacturer refuses any
responsibility in cases where normal safety
measures are not observed.
1
Phase
2
Ground (yellow - green)
3
Neutral wire
Connecting the terminal board
The appliance incorporates an easily acces-
sible 6-pole terminal board whose jumpers
(bridges) are already pre-set for operation on
400 V three-phase with neutral wire. In case
where different mains voltage is present, the
jumpers on the terminal board must be ar-
ranged as shown on the picture.
°
C
1
The ground cable must be connected to ter-
minal
.
After connecting the supply cable to the ter-
minal board, secure it with a junction clamp.
Service and spare parts
If your appliance does not work correctly,
even after carrying out all the checks which
are listed in the previous chapter, then please
contact your local Service Centre, specifying
the type of malfunctioning, the appliance
model (Mod.), the product number (Prod.
No.) and the serial number (Ser. No.) marked
on the identification plate. This plate is placed
on the front external edge of the oven cavity
5
2
3
4
electrolux 19
Advertisement
Table of Contents
