Checking For Blockages - Shark NV22LWM Owner's Manual

Checking for Blockages

Blockages may cause your vacuum
to overheat and shut down. If so,
clear the blockages, then follow the
instructions for Resetting the
Motor Thermostat on page 12.
W ARNING: Never insert sharp
objects into any opening to clear
an obstruction.
I MPORTANT: Damages caused
while clearing or attempting to
clear blockages are not covered
under your product's limited
warranty.
Unplug the vacuum
before checking for
blockages.
Reassemble all parts
securely before
operating vacuum.
1
2
1
1 Dust Cup Air Duct:
S tand vacuum into upright
position.
R emove Dust Cup Assembly and
empty Dust Cup if necessary.
D isconnect the Super Stretch
Hose.
C heck Air Duct behind Dust Cup
for clogs; clear before replacing
Dust Cup Assembly.
2 I ntake Opening behind the
Brush Roll:
4
L ay the vacuum flat to expose
Brush Roll.
C heck opening behind the Brush
Roll for clogs.
Clear the opening.
3
C lear the Brush Roll; use scissors
to carefully cut away threads,
hair or other debris that might
be trapped in the bristles.
2
3 F loor Power Nozzle Hose
Connector:
Lay vacuum flat.
R emove Nozzle Hose and check
for clogs.
P ush the Hose Connector back
onto the Floor Power Nozzle.
4 Hose:
Stand vacuum upright.
R emove hose from both the unit
and Cleaning Wand ends.
I nspect both ends and the length
of the hose for clogs.
Return the hose to the unit
www.sharkclean.com
English
3
11