What To Do If - AEG BE2000201 User Manual

24

What to do if...

2. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3. Pull the door trim to the front to re-
move it.
4. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF...
WARNING!
Refer to "Safety information" chapter.
Problem
The oven does not heat up
The oven does not heat up
The oven lamp does not oper-
ate
Steam and condensation settle
on the food and in the oven
cavity
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Possible cause
The oven is not switched on
The fuse in the fuse box is re-
leased
The oven lamp is defective
You left the dish in the oven
for too long
B
Remedy
Switch on the oven (refer to
chapter "Daily use").
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
Replace the oven lamp
Do not leave the dishes in the
oven for longer than 15-20 mi-
nutes after the cooking process
ends
.........................................
.........................................