Traffic Announcements Using Tmc; The Reset Button - Becker READY 45 LMU Operating Manual

>>> NAVIGATION MODE

The Reset button

You can reset the navigation settings to
> D
their factory settings.
> GB
The settings will then be reset. The fast
access mode data, stored routes,
> F
blocked routes, voice and home address
are retained.
> I
> PL
> Press the Reset
Yes
> Press the
The navigation settings are reset to their
factory settings.
84
Traffic announcements using
TMC (depending on the model)
Your Navigation device can receive
traffic announcements (TMC messages)
from radio stations. The power supply
with the integrated TMC antenna must
be connected to the carrier plate for this
function.
button.
Note:
TMC is not available in all countries..
Traffic announcements are transmitted
by radio stations via the TMC (Traffic
Message Channel) in addition to the
radio programme and are received and
analysed by the navigation system.
button.
Receiving traffic announcements is free
of charge.
Note:
As the traffic announcements are
transmitted by radio stations, we cannot
assume responsibility
completeness or accuracy of the
announcements.
Austria: The location and event code
was made available by ASFINAG and
BMVIT.
The Navigation device constantly checks
whether there are any
announcements for the route that has
been set. All traffic problems that have
been received are shown on the map.
If the continuous checks determine that
a traffic announcement is relevant to
route guidance, the
automatically recalculate a new route to
the destination (See "The TMC button" on
page 75).
for the
relevant
unit can