Yamaha XJR1300 Owner's Manual page 78

PERIODIC MAINTENANCE AND MINOR REPAIR
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
6
1. Speedometer gear unit retainer
2. Lift the wheel up between the fork
EAU04360
legs.
NOTE:
_
Make sure that the slot in the speedom-
eter gear unit fits over the retainer on
the fork leg.
_
3. Insert the wheel axle.
4. Install the brake calipers by install-
ing the bolts.
NOTE:
_
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
_
5. Install the brake hose holders by
6. Take the motorcycle off the cen-
7. Tighten the wheel axle, then the
8. Connect the speedometer cable.
9. Push down hard on the handlebar
6-33
installing the bolts.
terstand so that the front wheel is
on the ground.
front wheel axle pinch bolt and the
brake caliper bolts to the specified
torques.
Tightening torques:
Wheel axle:
72 Nm (7.2 m·kgf)
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf)
Brake caliper bolt:
40 Nm (4.0 m·kgf)
several times to check for proper
fork operation.