Rear Brake Light Switch Adjustment - Yamaha XJR1300 Owner's Manual

WARNING
_
A soft or spongy feeling in the brake
pedal can indicate the presence of
air in the hydraulic system. If there
is air in the hydraulic system, have a
Yamaha dealer bleed the system be-
fore operating the motorcycle. Air in
the hydraulic system will diminish
the braking performance, which
may result in loss of control and an
accident.
_
PERIODIC MAINTENANCE AND MINOR REPAIR
EW000109
Rear brake light switch
adjustment
The rear brake light switch, which is ac-
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
1. Remove panel A. (See page 6-5
for panel removal and installation
procedures.)
EAU01756
1. Rear brake light switch
2. Rear brake light switch adjusting nut
2. Turn the adjusting nut while hold-
3. Install the panel.
6-18
ing the rear brake light switch in
place. To make the brake light
come on earlier, turn the adjusting
nut in direction a. To make the
brake light come on later, turn the
adjusting nut in direction b.
6