Sidestand; Ignition Circuit Cut-Off System - Yamaha XJR1300 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Sidestand

The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
motorcycle upright.
NOTE:
_
3
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See further down for an explanation of
the ignition circuit cut-off system.)
_
EAU00330
WARNING
_
The motorcycle must not be ridden
with the sidestand down, or if the
sidestand cannot
moved up (or does not stay up), oth-
erwise the sidestand could contact
the ground and distract the opera-
tor, resulting in a possible loss of
control. Yamaha's ignition circuit
cut-off system has been designed to
assist the operator in fulfilling the
responsibility of raising the side-
stand before starting off. Therefore,
check this system regularly as de-
scribed below and have a Yamaha
dealer repair it if it does not function
properly.
_
EW000044

Ignition circuit cut-off system

The ignition circuit cut-off system (com-
prising the sidestand switch, clutch
switch and neutral switch) has the fol-
be properly
lowing functions.
Periodically check the operation of the
ignition circuit cut-off system according
to the following procedure.
3-17
G
It prevents starting when the trans-
mission is in gear and the side-
stand is up, but the clutch lever is
not pulled.
G
It prevents starting when the trans-
mission is in gear and the clutch
lever is pulled, but the sidestand is
still down.
G
It cuts the running engine when
the transmission is in gear and the
sidestand is moved down.
EAU03741