1. Locknut
2. Drive chain slack adjusting bolt
3. Axle nut
Rear wheel
To remove the rear wheel
WARNING
_
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
_
1. Loosen the axle nut and the brake
caliper bolts.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Bolt
2. Brake torque rod
3. Nut
4. Brake caliper bracket
EAU04413
5. Brake caliper
6. Bolt (× 2)
2. Disconnect the brake torque rod
from the brake caliper bracket by
EW000122
removing the nut and the bolt.
3. Place the motorcycle on the cen-
terstand.
1. Wheel axle
4. Remove the axle nut and the
CAUTION:
_
Do not apply the brake after the
brake caliper has been removed,
otherwise the brake pads will be
forced shut.
_
5. Loosen the locknuts, and then turn
6. Push the wheel forward, and then
6-34
brake caliper by removing the
bolts.
the drive chain slack adjusting bolt
on each side of the swingarm fully
in direction a.
remove the drive chain from the
rear sprocket.
ECA00082
6