Replacing An Auxiliary Light Bulb; Supporting The Motorcycle - Yamaha TDM900 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing an auxiliary light
bulb
1. Remove the auxiliary light lens by
1 removing the screws.
2
3
4
2
5
1. Auxiliary light lens
6
2. Screw
2. Remove the burnt-out bulb by pull-
7
ing it out.
8
9
EAU36452
1
1. Auxiliary light bulb
3. Insert a new bulb into the socket.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
1
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
[ECA10681]
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
6-34
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
EAU24350