Tachometer Unit - Yamaha TDM900 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
will stop flashing, however the immobi-
lizer system is still enabled.
TIP
This model is also equipped with a
1
self-diagnosis device for the immobiliz-
er system. If the immobilizer system is
2 not working correctly, the indicator light
will start flashing a pattern and the
odometer/tripmeter will display a 2-digit
3
code when the key is turned to "ON".
When this occurs, have a Yamaha
4
dealer check the self-diagnosis system.
However, if the indicator light slowly
flashes five times, and then quickly
5
flashes two times repeatedly, error
code 52 will be displayed. This error
6
could be caused by signal interference.
If this occurs, try the following.
7
1. Use the code re-registering key to
start the engine.
8
TIP
Make sure there are no other immobi-
9
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
3-6

Tachometer unit

1
1. Tachometer
2. Tachometer red zone
3. Clock
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer needle will sweep once
across the r/min range and then return
to zero r/min in order to test the electri-
cal circuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 8000 r/min and above
EAU11911
2
3
ECA10031