Tachometer Unit; Self-Diagnosis Devices - Yamaha FZS1000T Owner's Manual

Tachometer unit

1. Tachometer
2. Tachometer red zone
3. Clock
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
CAUTION:
Do not operate the engine in the ta-
chometer red zone.
Red zone: 11500 r/min and above
This tachometer unit is equipped with a
clock.
INSTRUMENT AND CONTROL FUNCTIONS
EAU11891 To set the clock
1. Push both the "SELECT" and "RE-
SET" buttons for at least two sec-
onds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
3. Push the "SELECT" button to
change the minutes.
4. When the minute digits start flash-
ing, push the "RESET" button to
set the minutes.
5. Push the "SELECT" button to start
the clock.
NOTE:
After setting the clock, be sure to push
the "SELECT" button before turning the
ECA10031
key to "OFF", otherwise the clock will
not be set.

Self-diagnosis devices

This model is equipped with a self-diag-
nosis device for the following electrical
circuits:
G
G
G
G
If any of those circuits are defective, the
tachometer will repeatedly display the
following error code:
Use the chart below to identify the
faulty electrical circuit.
3-4
throttle position sensor
speed sensor
EXUP system
overturn switch
Circuit-specific
0 r/min for
number of r/min
3 seconds
for 2.5 seconds
(See the table
below.)
Specific r/min for the faulty circuit
Throttle position sensor:
3000 r/min
Speed sensor:
4000 r/min
EXUP system:
7000 r/min
Overturn switch:
9000 r/min
EAU12101
3
Current
engine
speed for
3 seconds