Tachometer Unit - Yamaha TDM900 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
If this occurs, try the following.
1. Use the code re-registering key to
start the engine.
TIP
1
Make sure there are no other immobi-
lizer keys close to the main switch, and
2
do not keep more than one immobilizer
key on the same key ring! Immobilizer
3
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
4
2. If the engine starts, turn it off, and
try starting the engine with the
5
standard keys.
3. If one or both of the standard keys
6
do not start the engine, take the
vehicle, the code re-registering
7
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
8
9

Tachometer unit

1
1. Tachometer
2. Tachometer red zone
3. Clock
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer needle will sweep once
across the r/min range and then return
to zero r/min in order to test the electri-
cal circuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 8000 r/min and above
3-6
EAU11911 This tachometer unit is equipped with a
clock.
To set the clock:
1. Push both the "SELECT" and "RE-
SET" buttons for at least two sec-
onds.
2. When the hour digits start flashing,
push the "RESET" button to set the
2
hours.
3. Push the "SELECT" button to
3
change the minutes.
4. When the minute digits start flash-
ing, push the "RESET" button to
set the minutes.
5. Push the "SELECT" button to start
the clock.
TIP
●
After setting the clock, be sure to
push the "SELECT" button before
turning the key to "OFF", otherwise
the clock will not be set.
● When the key is turned to "OFF",
the clock display will remain on for
ECA10031
48 hours and then go off to prevent
the battery from discharging.