Yamaha TDM900 Owner's Manual page 55

5. Remove the oil filter element cover
by removing the bolts.
1
2
3
1. Engine oil drain bolt B
2. Oil filter element cover
3. Bolt
6. Remove and replace the oil filter
element and O-rings.
2
1. Oil filter element
2. O-ring
PERIODIC MAINTENANCE AND ADJUSTMENT
7. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
2
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Make sure that the O-rings are properly
seated.
8. Install the engine oil drain bolts,
and then tighten them to the spec-
ified torques.
Tightening torques:
Engine oil drain bolt A:
35 Nm (3.5 m·kgf, 25 ft·lbf)
Engine oil drain bolt B:
30 Nm (3.0 m·kgf, 21.7 ft·lbf)
1
9. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
6-10
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
3.80 L (4.02 US qt, 3.34 Imp.qt)
With oil filter element replacement:
3.90 L (4.12 US qt, 3.43 Imp.qt)
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
● Make sure that no foreign mate-
rial enters the crankcase.
2
3
4
ECA11620
5
6
7
8
9