Clutch Lever - Yamaha TDM900 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch " "
Press this switch to sound the horn.
2
Engine stop switch "
3
Set this switch to "
the engine. Set this switch to "
4
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
5
or when the throttle cable is stuck.
6
Start switch " "
Push this switch to crank the engine
7
with the starter. See page 5-1 for start-
ing instructions prior to starting the en-
gine.
8
9
The engine trouble warning light and
ABS warning light (ABS model only)
will come on when the key is turned to
"ON" and the start switch is pushed, but
this does not indicate a malfunction.
Hazard switch "
With the key in the "ON" or "
EAU12500
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
EAU12660 The hazard lights are used in case of
/ "
an emergency or to warn other drivers
" before starting
when your vehicle is stopped where it
" to
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12711
gine not running, otherwise the bat-
tery may discharge.
EAU44710

Clutch lever

EAU12733
"
" posi-
ECA10061 1. Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion
page 3-21.)
3-10
1
circuit cut-off system.
EAU12820
(See