Download Print this page

First Use - Electrolux ESI 67050 User Manual

Electrolux dishwasher
Hide thumbs


Table of Contents
6 electrolux
1) The salt and rinse aid indicator lights never come on while a washing programme is running even if
filling with salt and/or rinse aid is necessary.
Cancel button
With this button you can cancel a washing
programme or a delay start in progress.
Programme selection buttons
Press one of these buttons until the pro-
gramme indicator light of the desired pro-
gramme comes on.
Save energy button
This function decreases the temperature in
the drying phase. Energy saving is between
10% and 25%.
Dishes can be wet at the end of the pro-
gramme. In this condition we recom-
mend, to open the dishwasher door and
keep it ajar and let dishes dry naturally.
This function can be set with all washing pro-
grammes. The related indicator light comes
on when you press the button.
The save energy function has no effect on
some programmes. Refer to 'Washing pro-
grammes' for the list of programmes where
save energy has or not effect.
Delay start button
You can delay the start of the programme for
between 1 and 19 hours.
Refer to 'Select and start a washing pro-
gramme' chapter for the set of this function.
The digital display
The digital display indicates:
• the level of hardness to which the water
softener is set,
• the approximate remaining time of the run-
ning programme,
• activation/deactivation of the rinse aid dis-
penser ( ONLY with multitab function ac-

First use

Before using your dishwasher for the first
• Ensure that the electrical and water con-
nections comply with the installation in-
Indicator lights
Comes on when the special salt has run out.
• the end of a washing programme (a zero
will appear in the digital display),
• the countdown for the delay start,
• fault codes concerning malfunction of the
Light bar
Switch on the appli-
Switch off the appli-
Function buttons (A, B and C)
The following functions can be set using
these buttons:
• adjustment of the water softener level,
• activation/deactivation of the rinse aid dis-
penser when multitab function is active.
Setting mode
The appliance must be in setting mode
when you:
– select a washing programme,
– adjust the water softener level,
– activate/deactivate the rinse aid dis-
Switch on the appliance.
– All programme indicator lights come on,
the appliance is in setting mode.
Switch on the appliance.
– Only one programme indicator light comes
on, the last selected programme is still set.
In this case, to go back to the setting
mode, you must cancel the programme.
– Simultaneously press and hold the cancel
button until all the programme indicator
lights come on. The programme has been
cancelled and the appliance is now in set-
ting mode.
• Remove all packaging from inside the ap-
• Set the water softener level
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
Light bar comes on.
Light bar goes off.


Table of Contents

  Related Manuals for Electrolux ESI 67050