2 electrolux Share more of our thinking at www.electrolux.com CONTENTS Safety information Product description Control panel Use of the appliance Setting the water softener Use of dishwasher salt Use of detergent and rinse aid Multitab function SAFETY INFORMATION Before the installation and use, read this manual carefully: •...
Page 3
– If the water inlet hose or the safety valve are damaged, immediately dis- connect the mains plug from the mains socket. – Contact the service centre to replace the water inlet hose with safety valve. Warning! Dangerous voltage. electrolux 3...
Page 4
4 electrolux Electrical connection • The appliance must be earthed. • Make sure that the electrical information on the rating plate agrees with the power supply. • Always use a correctly installed shock- proof socket. • Do not use multiple plugs and extension cables.
PRODUCT DESCRIPTION Upper basket Water hardness dial Salt container Detergent dispenser Rinse aid dispenser Rating plate Filters Lower spray arm Upper spray arm electrolux 5...
6 electrolux CONTROL PANEL On/off button Light bar Display Delay start button Energy saver button Multitab button Programme buttons Cancel button Indicators Programme indicators Function buttons Salt indicator. It comes on when it is necessary to fill the salt container.
Page 7
– The display shows the time of the wash- ing programme or of the delay start. – It is necessary to cancel the pro- gramme or the delay start to go back to the setting mode. Refer to 'Setting and starting a washing programme'. electrolux 7...
8 electrolux USE OF THE APPLIANCE 1. Be sure that the set level of the water softener agrees with the water hardness in your area. If not, adjust the water softener. 2. Fill the salt container with dishwasher salt. 3. Fill the rinse aid dispenser with rinse aid.
10 electrolux 5. Close the detergent dispenser. Press the lid until it locks into position. Use long washing programmes when you use the detergent tablets. These cannot fully dissolve with short washing programmes and can decrease the washing results. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains.
• The programme time flashes in the display. After some seconds, the time stops to flash and the washing pro- gramme starts automatically. Interruption of a washing programme • Open the appliance door. – The washing programme stops. electrolux 11...
12 electrolux • Close the appliance door. – The washing programme continues from the point of interruption. Cancelling the washing programme If the washing programme has not started, you can change the selection. To change the selection while the washing programme operates, it is necessary to cancel the programme.
6. Fully clean the filter (B) with water. 7. Put the filter (B) to its initial position. Make sure that it assembles correctly in the two guides (C). electrolux 13 Water (litre) 8 - 15 13 - 14 9 - 11...
14 electrolux 8. Put the filter (A) into position in filter (B). Turn the filter (A) clockwise until it locks. WHAT TO DO IF… The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (re- fer to the table).
The detergent can be the cause. The washing programme was without a drying phase or with a decreased drying phase. electrolux 15 Possible solution Replace the fuse. • Cancel the delay start. • When the countdown is completed, the washing pro- gramme starts automatically.
16 electrolux Problem The dishes are wet and matt. Activating the rinse aid dispenser 1. Activate the appliance. Make sure that the appliance is in setting mode. 2. Press and hold function button (B) and function button (C) at the same time un-...