Table of Contents
Advertisement
• The indicator
• The remaining indicators are off.
• The display shows the current setting:
–
= AirDry is deactivated.
–
= AirDry is activated.
8. BEFORE FIRST USE
1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for
up to 5 minutes. The washing phase starts
only after this procedure is complete. The
procedure is repeated periodically.
8.1 The salt container
CAUTION!
Use only regeneration salt for
dishwashers. Do not use kitchen salt.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
still flashes.
2. Press
3. Press the on/off button to confirm the
4. Carefully shake the funnel by its handle to
5. Remove the salt around the opening of
6. Turn the cap clockwise to close the salt
to change the setting.
setting.
get the last granules inside.
the salt container.
container.
CAUTION!
Water and salt can come out of the salt
container when you fill it. To prevent
corrosion, fill the salt container and then
immediately start a complete
dishwashing cycle with detergent.
ENGLISH
13
Advertisement
Table of Contents
