Basic Operating Procedure - Omron CP1E Series User Manual

1-2

Basic Operating Procedure

In general, use the following procedure.
1. Setting Devices and Hardware
Connect the CPU Unit, Expansion I/O Units, and Expansion Units.
Set the DIP switches on the Option Board and Expansion Units as required.
Refer to Section 3 Part Names and Functions and Section 5 Installation and Wiring in the CP1E CPU Unit
Hardware User's Manual (Cat. No. W479).
2. Wiring
Wire the power supply, I/O, and communications.
Refer to Section 5 Installation and Wiring in the CP1E CPU Unit Hardware User's Manual (Cat. No. W479).
3. Connecting Online to the PLC
Connect the personal computer online to the PLC.
Refer to Section 4 Programming Device in the CP1E CPU Unit Hardware User's Manual (Cat. No. W479).
4. I/O Allocations
Allocations for built-in I/O on the CPU Unit are predetermined and memory is allocated automatically
to Expansion I/O Units and Expansion Units, so the user does not have to do anything.
Refer to Section 8 I/O Allocation in the CP1E CPU Unit Software User's Manual (Cat. No. W480).
5. Software Setup
Make the PLC software settings.
With a CP1E CPU Unit, all you have to do is set the PLC Setup.
Refer to Section 4 Initial Settings for CPU Unit and Section 9 PLC Setup in the CP1E CPU Unit Software
User's Manual (Cat. No. W480).
6. Writing the Programs
Write the programs using the CX-Programmer.
Debug the programs offline using the CX-Stimulator.
Refer to Section 5 Programming Concepts in the CP1E CPU Unit Software User's Manual (Cat. No.
W480).
7. Checking Operation
Check the I/O wiring and the Auxiliary Area settings, and perform trial operation.
The CX-Programmer can be used for monitoring and debugging.
Refer to Section 10 Overview and Allocation of Built-in Functions and 17-8 Debugging in the CP1E CPU
Unit Software User's Manual (Cat. No. W480).
8. Basic Program Operation
Set the operating mode to RUN mode to start operation.
CP1E CPU Unit Hardware User's Manual(W479)
1 Overview and Specifications
1
1-9