Da-Lite CINEMA CONTOUR SCREEN Instruction Book page 5

METHOD 4 (HIGH POWER
1. Secure the large wall bracket to wall studs at the
desired height. Make sure the bracket is level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen. See Figure 8.
#10 SCREWS
4-PIECES
FIGURE 8
2. Attach two High Power
frame rail as shown in Figure 8. use the black #10
screws supplied.
3. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
4. Position the screen with the attached surface
onto the top wall bracket as shown in Figure 6.
Push down at the center of the bottom frame rail
to tension the fabric. Mark the screw holes for
the bottom brackets. Drill holes in wall and attach
the brackets to the wall with screws.
® )
LARGE WALL
BRACKET
1-PIECE
HIGH POWER ®
BRACKET
2-PIECES
® brackets to the bottom
CLEANING
Da-Tex ® , Dual Vision, Pearlescent, Cinema Vision, High
Power ® , Da-Mat ® , High Contrast Da-Mat
High Contrast Audio Vision, High Contrast Cinema Vision
and High Contrast Cinema Perf surfaces can be
cleaned as follows:
Using a white clean cloth (100% cotton preferred)
that is dampened with clear water, gently wipe the
area in one direction. Do not use a circular motion.
Using a dry 100% cotton cloth, wipe dry after each
cleaning session. To clean a stubborn stain or a
sticky surface, use denatured alcohol (methanol or
methyl alcohol) following the same procedure as for
water.
4
® , Audio Vision,