Da-Lite CINEMA CONTOUR SCREEN Instruction Book page 4

METHOD 2 (SCREENS OVER 80" UP TO 96" IN
VIEWING WIDTH)
1. Secure the wall bracket to wall studs at the
desired height. Make sure the bracket is level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen. Figure 5 and 6 show the proper
orientation for the supplied wall brackets.
FIGURE 5
OVERALL HEIGHT
FIGURE 6
2
2. To install the bottom large wall bracket, you must
measure the overall height of the screen frame
and subtract 1/4". This is the dimension from the
top of the upper wall bracket to the bottom of the
bottom wall bracket. See Figure 6.
3. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
4. Position the screen with the attached surface
onto the top wall bracket as shown in Figure 6.
Push down at the center of the bottom frame rail
to hook onto the lower wall bracket.
LARGE WALL
BRACKET
2-PIECES
1
OVERALL HEIGHT
LESS 1/4"
METHOD 3 (SCREENS OVER 96" IN VIEWING
WIDTH)
1. Secure the wall brackets to wall studs at the
desired height. Make sure the brackets are level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen. Figure 6 and 7 show the proper
orientation for the supplied wall brackets.
FIGURE 7
2. To install the bottom large wall bracket, you must
measure the overall height of the screen frame
and subtract 1/4". This is the dimension from the
top of the upper wall bracket to the bottom of the
lower wall bracket. See Figure 6.
3. Some large screen sizes (240") are made with 2-
piece side frame rails. For this type of frame you
will need to attach one High Power
each side at the joint. Use the black #10 screws
supplied. See Figure 7.
4. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
5. Position the screen with the attached surface
onto the top wall bracket as shown in Figure 6.
Push down at the center of the bottom frame rail
to hook onto the lower wall bracket.
6. If you attached brackets to the side frame rails in
step 3, anchor these to the wall with an
appropriate fastener for your type of wall.
3
LARGE WALL
BRACKETS
3-PIECES
HIGH POWER
BRACKET FOR
LARGE SPLIT
FRAMES
ONLY.
2-PIECES
® bracket to
®