Testing Your System; System Testing - ADT Safewatch Pro 3000 System Manual

Safewatch Pro 3000 System Manual
Authority Level
Access Group
User's Partition Partition 1 =
users 03-32 Partition 2 =
users 33-49
RF User Number
Pager On/Off

System Testing

Testing Your System

Testing allows for each protection point to be checked for proper operation. While the touchpad will beep
every 40 seconds during TEST mode, no alarm messages will be sent to the Customer Care Center. We
recommend testing the system once a month.
To test the system:
1. Disarm the system and close all protected areas. The READY light will appear.
2. Enter your [security code] + [5] then [0] (walk).
3. The external sounder should sound for 1 second. If it does not sound, call for service.
4. Go through each fault zone individually. Open each door/window and listen for three beeps from
the touchpad. The zone number or description should appear on the display and clear when the
https://alpha.adt.com/help/63[11/12/2018 9:41:21 PM]
Mast/Prog code + [8] + [user
no.] + [#][1] + authority level
Mast/Prog code + [8] + [user
no.] + [#][2] + group (1-8)
Master Code [8] + [user no.] +
[#][3]+ partition(s) + [#] (to
end)
Mast/Prog code + [8] + [user
no.] + [#][4] + zone number
Mast/Prog code + [8] + [user
no.] + [#][5] + 0 or 1
0 = standard user; 1 = arm only; 2 =
guest; 3 = duress; 4= partition
programmer
You can assign users to a group and
then set an access schedule that defines
the times this group can operate the
system. The system will ignore these
users outside of the scheduled times.
Use this command to assign the
partitions a specific user can access.
Enter the numbers sequentially, then
end the entry with [#]. 0 = clears
partition 1 and partition 2 assignments; 1
= partition 1; 2 = partition 2; 3 = common
partitions
Use this command to assign a wireless
button device (keyfob) to this user. For
the zone number, enter the number
assigned to a button on the keyfob that
will be used for arming/disarming by this
user.
Program a user to receive a message to
their pager whenever this code is used
to arm/disarm. 1 = allow paging; 0= no
paging for this user.