Spectrum Analyzer Operation - Yaesu VX-5R Operating Manual

The Spectrum Analyzer allows viewing operating activity on channels above or below the
current operating channel in the VFO mode.
The display indicates the relative signal strength on channels immediately adjacent to the
current operating frequency.
Two basic operating modes for Spectrum Analyzer are available:
SINGLE SINGLE
SINGLE SINGLE SINGLE
Sweep: In this mode, the transceiver sweeps the current band once.
CONTINUE CONTINUE CONTINUE
CONTINUE CONTINUE
:
Setting the Spectrum Analyzer mode
•
Press the [ F/W ] key, then press the [ BAND ( SET ) AR ] key, to enter the SET mode.
‚
Rotate the DIAL to select Menu #34 ("SPEC-ANAL
ƒ
Press the [ BAND ( SET ) AR ] key to enable changing of this Menu item.
„
Rotate the DIAL to select the desired Spectrum Analyzer mode (see above).
...
When you have made your selection, press the PTT key to save the new setting and
exit to normal operation.
To Activate the Spectrum Analyzer:
•
Set the radio to the VFO mode in the desired band.
‚
Press the [ F/W ] key momentarily, then press the LAMP key.
When the Spectrum Analyzer is activated, eleven chan-
nels are viewed per sweep. The visible bandwidth, how-
ever, depends on the selected channel step size, so match
the default channel steps with the amateur band you are
using.
To turn the Spectrum Analyzer off and operate on the centered (and displayed) channel,
press the PTT switch momentarily, then press [ F/W ] key, followed by LAMP key.
VX-5R O
PERATING

Spectrum Analyzer Operation

In this mode, the transceiver sweeps the current band repeatedly until
the Spectrum Analyzer is turned off.
Downloaded by
RadioAmateur.EU
M
ANUAL
SPEC-ANAL"). SPEC-ANAL SPEC-ANAL
SPEC-ANAL
53